7-16
© Copyright Mahindra and Mahindra Ltd. 012019
Whenever the doors are opened, the engine start/stop button
will be illuminated and go off after few seconds.
Upon any fault identification by the system in the start/stop switch,
an alert would be provided in the Instrument cluster. Please visit the
nearest Authorised Mahindra Dealer immediately to rectify the
problem.
Even with the failure in the start/stop switch, vehicle's normal
function may work which depends on the severity of the failure.
Please visit the nearest Authorised Mahindra Dealer to rectify
the problem immediately.
EEnnggiinnee ssttaarrtt//ssttoopp bbuuttttoonn ppoossiittiioonnss::
To operate the engine start/stop switch to its intended function,
Smart Key should be inside the vehicle.
OOFFFF
To turn off the engine, stop the vehicle and press the engine start/
stop button once. Status LED in the engine start/stop button goes
OFF to indicate the OFF position.
If the engine is not switching off by pressing the engine start/
stop button (one press), press and hold the engine start/stop
button for more than 3 seconds or rapidly press and release
the engine start/stop button 3 times within 3 seconds. On
doing so, the vehicle ignition status is changed to ACC position
till 30 seconds, then it will change to OFF position. Contact the
nearest Authorised Mahindra Dealer at the earliest.
Your vehicle is equipped with electronic anti-theft steering column
lock. The steering wheel locks when the engine start/stop button is
in OFF position to protect against the theft. The steering wheel locks
automatically when the driver door is opened or 25 seconds after
engine start/stop button changes to OFF position. If the steering
wheel is not locked properly when you open the driver door and on
attempting to lock the vehicle, a warning chirp along with the
hazard blinks thrice. Try locking the steering wheel again (by
toggling Engine Start/Stop button). If the problem is not solved, we
recommend to take the vehicle to nearest Authorised Mahindra
Dealer immediately.
OONN
To switch ON the ignition, press the engine start/stop button when
the switch position is in OFF/ACC without depressing the clutch
pedal and with the Smart Key inside the vehicle. Status LED in the
engine start/stop button will turn Red to indicate the IGN ON
position and the vehicle is ready for starting.
LLOOCCKKSS AANNDD KKEEYYSS
To Next Page
Loading...
Need help?
General
