SRS
Repair Manual
Nov 2011/ Rev 2
MAN-00162
22-13
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications current at the time of
release. The methods may be modified as a result of changes introduced by the manufacturer in the production of the various
component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in
part of whole of the present document, are prohibited without the prior written consent of © 2011 Mahindra & Mahindra Ltd.
SRS ECU
A. SRS ECU
Removal
1. Disconnect and isolate the negative terminal of
the battery. For additional information refer
to Battery removal and installation section.
2. Pull out the side trims (A) from both the sides
of the floor console.
3. Unlock the lock and disconnect the two SRS
module electrical connectors (A) from the SRS
module which is located below the RHS HVAC
unit.
4. Loosen the 10mm SRS ECU earth mounting
nut (A) and disconnect the earth connection,
remove the three SRS ECU mounting nuts (B)
and detach the SRS ECU.
Installation
1. To install, reverse the removal procedure.
Notice
Carefully remove the side trims without
damaging the trim locks.
A
To Previous Page
Loading...
