13-8
Drive Shaft
Repair Manual
MAN-00162
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications current at the time of
release. The methods may be modified as a result of changes introduced by the manufacturer in the production of the various
component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in
part of whole of the present document, are prohibited without the prior written consent of © 2011 Mahindra & Mahindra Ltd.
Nov 2011/ Rev 2
4. Remove the 36mm LHS halfshaft lock nut (A).
5. Remove the tie rod end. For additional inform-
tion refer to Tie-rod Ends removal and instal-
lation section.
6. Unclip the wheel speed sensor wire (A) from
the strut assembly.
7. Remove the two 24mm strut mounting bolts (A)
and nuts (B) from bottom of the strut assembly.
8. Detach the halfshaft from the LH knuckle.
9. Remove the LH halfshaft assembly from the
transmission.
Installation
1. To install, reverse the removal procedure.
Notice
While removing halfshaft, support the lower
control arm using jack to avoid damage of
halfshaft rubber boot and brake disc.
Notice
While removing the LHS halfshaft, collect the
oil from the transmission using a container to
avoid oil spilling.
To Next Page
Loading...
