198 © Copyright Mahindra & Mahindra Ltd. v062012
STARTING YOUR VEHICLE
RPM runs higher than normal in order to warm the engine.
The engine idle speed RPM reduces once the engine warms
up.
Ignition Switch
An illuminator ring is provided on the face of the ignition
switch to help in locating the ignition switch at night. The
ring will illuminate the moment the driver door is opened and
will remain glowing till the driver door is closed.
The different positions of the ignition switch are;
LOCK - This is the ignition and steering lock position. The
vehicle circuits and engine is completely switched OFF. The
steering wheel is also locked and the key can be removed
from the ignition only in this position.
ACC - The steering is unlocked and can be rotated. In this
position all electrical circuits are enabled. Use this mode
when you want to listen to music, etc., with the engine
temporarily switched OFF.
ON - All electrical circuits are enabled. Some of the warning
or information lamps illuminate in this position. While some
of the lamps will go out after a few seconds, some will
continue to remain ON till the engine is started. When the
vehicle is being driven, ignition switch remains in the ON
position.
NOTICE
Preferably select the ignition ON position when the
vehicle is being towed.
NOTICE
Do not leave the ignition in ON when the engine is OFF.
This could lead to battery drain and ignition switch
damage.
To Next Page
Loading...
