222 © Copyright Mahindra & Mahindra Ltd. v062012
DRIVING YOUR VEHICLE
• Clean the sensors and make them free of ice, dust,
water etc. for proper working of the system.
• System will not work properly if the sensor
orientation is changed.
CAUTION
• The distance of the obstacle displayed is from the
rear bumper.
• This system is an aiding system and it should not
replace the need to drive carefully. Under no
circumstances will the manufacturer accept any
responsibility or can be held liable for any direct
or indirect, incidental or consequential damage
caused by this system.
• System will not sense pot holes, trenches or
drainage which are below the ground level.
• Any sort of paint or any adhesive on the sensor
faces will not guarantee the proper functioning of
the system.
• Applying pressure on sensor face may deteriorate
the system performance, so care should be taken
while replacing sensors. In the event sensor found
damaged kindly don't attempt to replace them by
yourself, bring to the notice of your dealer.
• Bumper covered with guards and other accessories
may not allow sensors to function properly.
Stop/Start System (if equipped)
Stop/Start system automatically “stops” and “starts” the
engine when idle at signals or long traffic jams. This in turn
gives a better fuel efficiency. Stop/Start system is activated
by default in every ignition cycle. It can be disabled by the
Stop/Start button on the switch bank in the center bezel.
How Does the Stop/Start System Work?
Let’s take a simple example of driving in traffic conditions
within your city. Assume that your vehicle has stopped at a
To Next Page
Loading...
