EMERGENCIES
© Copyright Mahindra & Mahindra Ltd. v062012 263
15
drive slowly to the nearest service station and inflate to the
correct pressure. If it is too high, adjust it until it is correct.
Always reinstall the valve cap after checking or adjusting tyre
pressure. If the cap is not replaced, dirt and moisture could
get into the valve core and cause air leakage. If you lose a
valve cap, buy another and install it as soon as possible.
Jump Starting
If your vehicle's battery has run down, you may be able to
start the engine by using a booster battery. Although this
seems like a simple procedure, you should take several
precautions while you are at it.
Open the bonnet and check the physical condition of the
battery. If the weather is very cold, check the condition of
the electrolyte. If it seems slushy or like ice, do not attempt
jump-starting until it thaws.
WARNING
!
Connect the negative lead to a point away from the
battery.
Connect the jumper cable leads away from moving
parts. The lead could get caught when the engine
starts and cause serious injury.
Follow the below listed starting procedures first;
1. Ensure that vehicle battery and battery for jump-
starting have the same declared voltage (say 12V)
2. Turn OFF all electrical loads, check vehicles - no part
should be touching each other and gear should be in
neutral position
3. Vehicles should have the same terminal earthed, if not,
refer to manufacturers' instructions
4. Make sure that cables are not frayed or damaged
5. Position both vehicles such that both the batteries are
accessible but the vehicles do not touch each other.
The steps to be followed when jump starting the vehicle are
as follows;
+
-
To Next Page
Loading...
