Issue: 1 - 01/03/2013 page 12 of 12
XUV500
Step 6: Final test and image alignment
With the engine running and the handbrake engaged, place the vehicle into reverse.
The reverse image should look similar to the below image. Some slight adjustment to the
camera may be necessary by loosening the camera in its housing adjusting to the correct
angle and re-tightening . Please note this reverse camera option activates in reverse only and
is not accessible via the “ Car Info / Reverse Camera ” Sub menu from the vehicles main
screen. This feature is inactive and will yield a black screen unless the vehicle is in reverse.
Photo of reverse image on screen
Once the desired image is achieved ,
perform a physical reversing test
.
To Previous Page
Loading...
