Issue: 1 - 01/03/2013 Page 8 of 12
XUV500
Camera Mounting.
Remove numberplate light housing, by undoing 2 x 10mm bolts from
inside the tailgate, then unclipping the housing from outside the vehicle
Remove switch from light housing
Remove passenger
Side screw, then
Refit screw with camera
Attached to assembly
Run camera cable back under metal bracket,
run camera cable adjacent to switch wiring.
Place a small cut in rubber grommet to allow
camera lead to pass through.
Fit Surround to vehicle as a reverse of removal.
To Next Page
Loading...
