Maintenance Manual MAN-00167
XYLO mHawk February 2012/ Rev1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra
Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution © 2012 Mahindra & Mahindra Ltd.
Pre Work for Wheel Alignment Process:
Tyre pressure : Should be as per recommendations in all the tyres.
Position of bolts : Observe the intial positon of the camber/ castor bolts.
Sequence
:
It is very important to torque all the camber/castor bolts to 200 Nm.
Shock Absorber Projection Height – 26.0 ± 1.0 mm.
Refer below sketch and photo to adjust Shock Absorber Projection Height.
Use MST No.0401BAA0005ST & refer Repair Manual for SOP.
Runout
•Do the runout compensation
Camber
•Adjust the camber setting by adjusting the front bolts
(refer sketch above)
Castor
•Adjust the castor setting by adjusting the rear bolts (refer
sketch above)
Indivudal
Toe In
•Set toe-in using the track rod ends.
Turning
angle
•Check the each wheel turning angle.
To Next Page
Loading...
