Need help?Do you have a question about the Mahr Pocket Surf EMD-1500-311 and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Measuring principle | Inductive |
| Standards | ASME B46.1 |
| Parameters | Ra, Rz, Rmax, Rt |
| Cut-off lengths λc | 0.25 mm, 0.8 mm, 2.5 mm |
| Operating Temperature | 40°C |
| Storage Temperature | -20 °C to 60 °C (-4 °F to 140 °F) |
| Resolution | 0.01 μm (0.4 μin) |
Defines the various measuring ranges available for the Pocket Surf gage.
Outlines the accuracy standards met by the Pocket Surf gage.
Lists the various model numbers for Pocket Surf kits based on probe and specimen combinations.
Defines Ra as the arithmetic average height of roughness within the evaluation length.
Defines Rmax as the largest peak-to-valley roughness depth in sampling lengths.
Defines Rz as the mean of maximum peak-to-valley roughness depths.
Defines Ry as the vertical distance between highest and deepest points within a sampling length.
Step-by-step guide for inserting or replacing the 9-volt battery.
Lists and explains various error codes like E1, E2, E3, E4, E5L.
Emphasizes the need to check calibration before operation.
Details critical contact requirements for valid measurements.
Describes how the gage can be used in the "Closed" position for various surfaces.
Instructions for aligning the unit and probe for non-closed positions.
Guidance on maintaining proper elevation and parallelism for accurate measurements.
Steps for setting up the gage and reference specimen for calibration.
How to set the parameter switch to Ra and traverse length to 5 for calibration.
How to compare readings to the specimen label for accuracy.
Steps to follow if readings are outside the acceptable tolerance.
How to use the calibration control to fine-tune the displayed value.
Ensures the Vee is parallel to the probe's axis of movement.
Adjusting distance for precise probe travel along the workpiece.
Adjusting Vee position for precise probe skid/stylus travel.
Description of a heavy-duty, adjustable stand for staging the Pocket Surf unit.
Description of a stand for measuring surfaces at varying heights.
Detailed steps for cleaning the Pocket Surf unit and its components.
Lists and explains common error codes displayed by the Pocket Surf.
Detailed actions for cleaning probe parts and replacing the battery.
Provides steps to resolve common issues like workpiece condition and setup alignment.
Information on when and how to contact Mahr Federal for repair services.
To Next Page