13
( WITH FIXED TABLE AND HINGED PUSHER ).
First check the condition of the hinged pusher (C).
Place the product to between the blade and the adjustable portioner (C). From the
working position and with your right hand place the product between the blade and
the pusher held by handle with the left hand. From there on, with the right hand
holding the piece to be cut and the left hand the pusher, start to exert steady
pressure on the pusher which will force the blade onto the product, resulting in a
sliced portion. (Fig. 2)
Only when the pusher reaches the end of its travel and remains in a vertical position,
can you remove the sliced product with your left hand. Once again, place your hand
on the pusher and lift it towards you, allowing the operation to move the main product
sideways to the stop, in preparation of the next slice.
( MOVING TABLE ).
First check working of the sliding table (F).
With the machine switched off, place the piece to be cut on the table (F) and adjust
the intermediate slot guide (G) to be 10mm above the high of the cut piece.
Next,press firmly the product held in your right hand against the vertical surface of
the moving table (fig.3). Switch the saw on and push the assembly forward to the end
of its travel. Thereon, remove the sawn piece with your left hand and return the table
to the forward position.
When slicing meat with bone you should take care by exerting greater pressure when
slicing meat as against bone, in order to protect the band and avoid excessive strain
on the motor.
( BM-3000JV MODEL WITH FOLDING MOVING TABLE ) WORKING WITH
MOVING TABLE FOLDED
With the machine stopped verify that the front of the sliding table (F) is in its inferior
position and blocked by the lock (W) of fixation, and the table quadrant (U) is locked
in its superior position, being totally flat the cutting surface.
Check the condition of the hinged pusher (C).
After table is folded, follow steps described on ( INSTRUCTIONS FOR USE, WITH
FIXED TABLE AND HINGED PUSHER ).
( BM-3000JV MODEL WITH FOLDING MOVING TABLE ) WORKING WITH
MOVING TABLE
For the cut with sliding table make sure first that this is released, otherwise, with
stopped machine it will be thrown of the handle of the table quadrant (U) upwards
and, maintaining it slightly inclined one will slide backwards until making end, then it
will let pivot downwards following until its vertical position.
In order to release the sliding table (Z) turnright the locker (W) and turn the front
protector to its superior position, fix with same pin in hole of sliding table (F).
For the use of the sliding table it is obligatory that the front protector is vertical
making a wall to 90º with the surface of the table.
To Next Page
Loading...
