Need help?Do you have a question about the Majestic fireplaces SH48 and is the answer not in the manual?
General| Brand | Majestic fireplaces |
|---|---|
| Model | SH48 |
| Category | Indoor Fireplace |
| Language | English |
Describes the initial steps for installing the fireplace unit.
Check installation instructions for accessories before proceeding with fireplace setup.
Identify suitable surfaces and clearances for placing the fireplace.
Install protective metal strips at the fireplace base for safety.
Secure the fireplace to the floor using brackets to prevent shifting.
Determine ceiling centerpoints for straight and offset chimney runs.
Mark, cut, and frame the ceiling hole for the chimney.
Install firestop spacers for safety at ceiling penetrations.
Connect chimney sections, elbows, and supports according to installation.
Locate and prepare subsequent ceiling holes and continue chimney assembly.
Mark the roof centerpoint for the chimney exit.
Cut and frame the roof opening for the chimney.
Ensure chimney meets minimum height codes above the roof.
Install the chimney top housing or termination according to instructions.
Install flashing and top for chimney in a chase.
Insulate the fireplace base with non-combustible material.
Inspect and seal all fireplace and finishing material joints.
Insulate the fireplace enclosure like an exterior wall.
Decide when to install the fireplace framing.
Construct the fireplace framing using lumber.
Apply wall finishing materials around the fireplace.
Protect adjacent combustible side walls from heat.
Install a hearth extension to protect the floor.
Details minimum air space requirements for safety.
To Next Page