MTD8
DIGITAL PROGRAMMABLE TIMER
45
65
DIGIT
AL PROGRAMMABLE TIMER
MTD8
Timer: 16 ON & 16 OFF
18 Pulse Times: 1 Sec - 59 Min 59 Sec
Count Down: 1 Sec - 99 Min 59 Sec
IEC 60730 -2-7
IEC 60730-1
Input: 220 - 240V AC (50/60Hz)
Load: 30A Resistive Load
(4400 Watts) Max
Circuit
Breaker
Timer
Live In Live In Neutral
Live Load Out
L N
36
86
OUT
L
30A DIGITAL
PROGRAMMABLE TIMER
MTD8
L
N
ON
D+
H+
M+
RESET
MANUAL
P
OUT
L
Circuit
Breaker
Live In
Neutral
Live Load Out
Live In
Features:
• Din Rail Mounted
• Advanced weekly settings
• Repeat programs with 16 ON/OFF settings, 18 pulse settings, and a manual ON/OFF switch
• Lithium battery back up in the event of a power failure
• MANUAL button changes between Manual ON/OFF, ON AUTO and AUTO OFF
• Terminology: ON (Always ON), OFF (Always OFF), AUTO ON (Timer remains ON until the next OFF programmed
setting) / AUTO OFF (Timer remains OFF until next programmed ON setting and turns OFF as per programmed
OFF settings)
• AUTO OFF – Automatically turns the timer ON and OFF as per the programmed settings
• While programming any function, 30 seconds of inactivity will exit all setting menus
Technical Data:
• Voltage Rating: 220V – 240V AC 50/60Hz
• Voltage Limit: ±10%
• Resistive Loads (Max): 30A
4400W
• Minimum Interval: 1 minute
• Countdown Interval: 1 second – 99 minutes & 59 seconds
• 18 Pulse Intervals: 1 second – 59 minutes & 59 seconds
• Ambient temperature: -10°C ~ 40°C
• Ambient Humidity: 35%RH ~ 85%RH
• Weight: 150g
• Certification: IEC60730-1, IEC60730-2-7
Dimensions: Wiring Diagram:
Installation Instructions:
1. All program settings explained below can be carried out before installation.
2. Press Reset Button to activate timer (only required when first installed).
3. Connect timer to 220V AC.
Setting the Clock:
1. Hold down the button to begin the process.
2. While holding down the button press the D+ button until you see the required day of the week displayed at the top
of the screen.
3. Continue holding down the button and press the H+ button until you see the required hour in the middle of the
screen.
4. Continue holding down the button and press the M+ button until you see the required minutes in the middle of the
screen.
5. Release the button and your time and date are set.
Weekly / Daily Programming:
1. Press P button once and you will see “1 On” on the bottom left side of the screen. This will be the first day and time
you would like the timer to come on.
To Next Page
Need help?
General
