9
Chamfering
To make a cut as shown in the figure, align the “V’’ groove in
the front base with the edge of the workpiece and plane it as
shown in the figure.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Sharpening the planer blades
Always keep your blades sharp for the best performance
possible. Use the sharpening holder to remove nicks and
produce a fine edge.
1. “V” groove
2. Front base
1. Align the (Y) groove with the edge
of the workpiece
001609
1
2
001613
1
001614
1. Sharpening holder
1
001610
To Next Page
Loading...
