CAUTION
:
.Only the Makita dado head
set
(Part No.
191543-4)
should be used with Makita table
.After dadoing, always replace the blade guard with the spreader back in
its
original posi-
0
Never attempt bevel cuts when dadoing.
0
Never dado if there
is
vibration (flutter) or
a
strange noise.
0
Never attempt dados in other than wood.
0
When using
a
dado head
set,
the depth of cut
is
not indicated by the pointer. (See the
cutting depth adjustment section.) To know the depth of cut, you must measure
it
with
a
ruler.
0
Do
not use the dado
set
for cut-offs.
Feed work slowly, especially when cutting deep or wide grooves or dados. Fast or
abrupt feeds can be dangerous.
*Use
a
pushstick. When the dado head
is
hidden from view while cutting, your hands
should never be on top of the stock.
*A
very dangerous throwback can result if the wood becomes stuck and you try
to
remove
it
by
pulling toward you. Always stop the tool and wait for dado head to come
to
a
complete stop. Then simply withdraw the wood.
saw Model
2708.
tion on the table saw.
25
To Next Page
Loading...
