Makita 2708 - Table Saw Installation; Securing the Table Saw; Cutting Depth Adjustment; Using the Depth Indicator

INSTALLATION
Secure the table saw so that it will not
move during operation. Bolt or screw the
cabinet to
a bench (see 4 hole's in the base)
or secure legs with screws.
Leave more than
30 cm (1 2") clearance
between the table and
a wall to allow chip
ejection.
9.62"
1244.3
mm)
7
I 15 26"
l(387 6 mm)
13.14"
(333.8
mml
Hole diameter 5/16" 18 mml
11
CUTTING DEPTH ADJUSTMENT
The cutting depth is obtained by raising or
lowering the blade with the elevating knob;
Move left to lower, right to raise
it. The
cutting depth indicator
tells you the depth
of cut by the arrow pointer.
NOTE: Use
a shallow depth setting when
cutting thin materials in order to
obtain
a cleaner cut.
8