7 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model 2712
Arbor hole 30 mm
Blade diameter 315 mm
Blade body thickness 2 mm or less
Max. cutting capacities Thickness at 90° 85 mm
Thickness at 45° 58 mm
Width 1,600 mm
No load speed 2,950 (min
-1
) (50 Hz) 3,400 (min
-1
) (60 Hz)
Table size (L x W) 550 mm x 1,600 mm with sub table (back)
Net weight 52.9 kg
Safety class Class I
•
Due to our continuing program of research and development, the specications herein are subject to change without notice.
• Specications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Do not place hand or ngers close to the
blade.
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
Intended use
The tool is intended for cutting in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the oper-
ator from electric shock. Use only three-wire extension
cords which have three-prong grounding-type plugs and
three-pole receptacles which accept the tool's plug.
Noise
The typical A-weighted noise level determined accord-
ing to EN1870-1:
Sound pressure level (L
pA
) : 93 dB (A)
Sound power level (L
WA
) : 105 dB (A)
Uncertainty (K) : 4 dB (A)
Wear ear protection
WARNING: The gures quoted are emission lev-
els and are not necessarily safe working levels. Whilst
there is a correlation between the emission and
exposure levels, this cannot be used reliably to deter-
mine whether or not further precautions are required.
Factors that inuence the actual level of exposure of
the workforce include the characteristics of the work
room and the other sources of noise etc.i.e. the num-
ber of machines and other adjacent processes. Also
the permissible exposure level can vary from country
to country. This information, however, will enable the
user of the machine to make a better evaluation of the
hazard and risk.
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Table Saw
Model No./ Type: 2712
Conforms to the following European Directives:
2006/42/EC, 2006/95/EC, 2004/108/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN1870-1, EN60204-1, EN55014-1, EN55014-2,
EN61000-3-2, EN61000-3-11
The EC Type-Examination Certicate
No.M6A.13.12.86528.002
The EC Type-Examination per 2006/42/EC was per-
formed by:
TÜV SÜD Product Service GmbH
Ridlerstraße 65. D-80339 München Germany
Identication No.0123
The Technical le in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
To Next Page
Loading...
