6
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Adjusting bit protrusion
To adjust the bit protrusion, loosen the lever and move the
tool base up or down as desired by turning the adjusting
roller. After adjusting, tighten the lever firmly to secure the
tool base.
Adjusting angle of tool base
Loosen the wing bolts and adjust the angle of the tool base
(5° per graduation) to obtain the desired cutting angle.
Adjusting amount of chamfering
To adjust the amount of chamfering, loosen the wing nuts
and adjust the trimmer shoe.
CAUTION:
• With the tool unplugged and switch in the “OFF” position,
rotate the collet nut on the tool several times to be sure
that the bit turns freely and does not contact the base or
trimmer shoe in any way.
1. Lever
2. Scale
3. Bit protrusion
4. Adjusting roller
1
2
3
4
002001
1. Wing bolt
2. Graduation
3. Trimmer shoe
4. Amount of chamfering
5. Base
1
2
3
4
5
002002
To Next Page
Loading...
