Makita 4351T - User Safety and Tool Operation; Personal Safety Guidelines; Power Tool Use and Care; Jig Saw Specific Safety Warnings

Repair
P 4 / 15
1. After separating Safety wire from Gear housing cover, remove four 4x16 Tapping screws CT .
Gear housing cover is separated from Gear housing as illustrated in Fig. 6.
[5] Disassembling Gear housing cover section
Tapping screws
CT 4x16
Gear housing cover
Gear housing
Fig. 6
Fig. 7
2. Remove Stop ring E-3 with slotted screwdriver.
Push Slider to the lower dead point. (Fig. 7)
Stop ring E-3
Pin 4
Rod
Slider
Slider in the lower
dead point
Rod
3. Slide Pin 4 in order to disconnect Rod with Slider. And then, pull out Rod from Gear housing cover.
Separate Linear guides from Gear housing by removing four M4x10 Pan head screws .
Pin 4, Slider and Leaf spring are disassembled from Gear housing cover. (Fig. 8)
Note: When reassembling, be sure to the direction of Leaf spring illustrated above.
Rod
Pin 4
Slider
Pin 4
Slider
Linear guides
Linear guides
Pan head
screws M4x10
Leaf spring
Gear housing cover
Fig. 8