Specific Safety Rules
1.
Hold tools by insulated gripping surfaces when performing an operation where
the cutting tool may contact hidden wiring or its own cord. Contact
with
a
"live" wire
will
make exposed metal parts
of
the tool "live" and shock the
operator.
2.
Hold the tool firmly with both hands.
3.
Make sure the belt is not contacting the workpiece before the switch is
4.
Keep hands away from rotating parts.
5.
Do
not leave the tool running. Operate the tool only when hand-held.
6.
This tool has not been waterproofed,
so
do not use water on the workpiece
turned on.
surface.
SAVE
THESE INSTRUCTIONS.
4
To Next Page
Loading...
