the
q
firm11
comi
t
bag, push
it
onto the dust spout
s
far
as it will go to prevent
it
from
off during operation.
best results, empty the dust bag
becomes about half full, tapping it
3
remove
as
much dust as possible.
Dust
bag
\:'is
"""
action
IN
plugging in the tool, always check to see that the switch trigger actuates properly
turns to the "OFF" position when released
01
should not be in contact with the workpiece surface when you turn the tool on
Otherwise
a
poor sanding finish or damage of the belt may result
t
the tool, simply pull the trigger.
!
the trigger to stop. For continuous
in, pull the trigger and then push in
:
button. To stop the tool from the
>osition, pull the trigger fully, then
it.
7
To Next Page
Loading...
