To Next Page

To Previous Page

8 ENGLISH

For DFS251

3 mm (1/8")

Fig.9

►1. Locator

Adjustthelocatorsothatthedistancebetweenthetip

of the locator and the screw head is approximately 3

mm(1/8")asshowninthegures.Driveatrialscrew

into your material or a piece of duplicate material. If the

depthisstillnotsuitableforthescrew,continueadjust-

ing until you obtain the proper depth setting.

Hook

CAUTION: Always remove the battery when

hanging the tool with the hook.

CAUTION: Never hook the tool at high location

or on potentially unstable surface.

Fig.10

►1. Hook

The hook is convenient for temporarily hanging the tool.

ASSEMBLY

CAUTION: Always be sure that the tool is

switched off and the battery cartridge is removed

before carrying out any work on the tool.

Installing or removing driver bit/

socket bit

For DFS250

Fig.11

►1. Locator

Fig.12

►1. Locator 2. Driver bit 3. Magnetic bit holder

To remove the driver bit, pull the locator, and then grasp

the bit with a pair of pliers and pull the bit out of the

magneticbitholder.Toinstallthedriverbit,pushitrmly

into the magnetic bit holder. Then install the locator by

pushingitrmlyback.

For DFS251

Fig.13

►1. Locator

Makita DFS251Y1J User Manual

Questions and Answers: