Makita DHS680 - Functional Description and Controls; Battery Cartridge Installation;Removal; Switch Operation and Lock-off Lever; Indicating Remaining Battery Capacity

Repair
DISASSEMBLING
(2) Adjust the locked position of Lever 45 so that it always leans toward base plate from 0 - 30°
when the machine is adjusted to the required cutting depth. (Fig. 11)
P 8/ 18
Fig. 11
0 -30°
Lever 45
E-8 Bow
stop ring
Be sure to mount E-8 Bow stop ring as shown below
for securely engaging Lever 45 with M6x20 Hex bolt.
M6 Hex nut
1. Remove Stop ring E-8 with a slotted
screwdriver, then separate M6 Hex nut,
Lever 45 and Flat washer 6 from
M6x90 Cap square neck bolt.
2. Remove seven 4x18 Tapping
screws and one M5x40 Pan
head screw to separate
Handle R complete.
3. Remove three M5x40 Pan
head screw. to separate
Motor housing.
E-8 Bow
stop ring
M6 Hex nut
Lever 45
Flat washer 6
[3] -3. Rotor
M5x40
Pan head
screw
4x18 Tapping
screw (7 pcs.)
M5x40 Pan
head screw
(3 pcs.)
(1) Remove Motor housing from Blade case section, and disassemble Rotor as drawn in Fig. 12.
Note: Rotor can be disassembled without removing Safety cover, Pipe 6 and M6x90 Cap square neck bolt.
Fig. 12
4. Remove Baffle plate from Motor housing. 5. Grip Ball bearing 609LLB by hand and pull it out
together with Rotor from Motor housing.
Ball bearing
609LLB
Baffle plate
Rotor
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Depth guide (cont.)
ASSEMBLING
Motor
housing