Makita DTM50 - Operation

10 ENGLISH
Hex wrench storage
1
►1.Hexwrench
Whennotinuse,storethehexwrenchasshowninthe
guretokeepitfrombeinglost.
OPERATION
WARNING:
• Before starting the tool and during operation,
keepyourhandandfaceawayfromtheapplica-
tion tool.
CAUTION:
• Donotapplyexcessiveloadtothetoolwhich
maycauseamotorlockandstopthetool.
Cutting, sawing and scraping
CAUTION:
• Donotmoveonthetoolforciblyinthedirection
(eg. towards either side) of tool application with
nocuttingedge.Itmaydamagethetool.
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
• Forcingorexcessivepressureonthetoolmay
reduceefciency.
• Before cutting operation, it is recommended to
preset the orbital stroke rate 4 - 6.
Sanding
CAUTION:
• Do not reuse a sanding paper used for sanding
metal to sand wood.
• Do not use a worn sanding paper or sanding
paper without grit.
Applyasandingpaperontheworkpiece.
NOTE:
• Usingatestmaterialsampletotryisrecom-
mendable to determine a correct orbital stroke
ratesuitableforyourwork.
• Use a sanding paper with the same grit until
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
sandingpapermaynotgetanenish.