Makita DTM50 - Indication Lamp

9 ENGLISH
Indication lamp
1
►1. Indication lamp
• Whentheremainingbatterycapacitygetslow,the
indication lamp blinks.
• Whentheremainingbatterycapacitygetsmuch
lower, the tool stops during operation and the
indication lamp lights up about 10 seconds.
Atthistime,removethebatterycartridgefromthetool
and charge it.
ASSEMBLY
CAUTION:
• Alwaysbesurethatthetoolisswitchedoffand
thebatterycartridgeisremovedbeforecarrying
outanyworkonthetool.
Installing or removing application
tool (optional accessory)
WARNING:
• Do not install application tool upside down.
Installingapplicationtoolupsidedownmay
damage the tool and cause serious personal
injury.
• Install attachment tool in the correct direction
accordingtoyourwork.Applicationtoolcanbe
installedatanangleofevery30degree.
1
3
2
►1. Application tool installation bolt 2. Holes in the
application tool 3.Protrusionsofthetoolange
1
2
3
►1. Application tool installation bolt 2.Hexwrench
3. Tighten
Putanapplicationtool(optionalaccessory)onthetool
angesothattheprotrusionsofthetoolangetinthe
holes in the application tool and secure the application
toolbytighteningtheboltrmlywiththehexwrench.
When using sanding application tool, mount the appli-
cation tool on the sanding pad so that it matches the
sanding pad direction.
Thesandingpadhasahookandlooptypettingsys-
temwhichallowseasyandrapidttingofasanding
paper.
Assandingpapershaveholesfordustextraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
usingahexwrenchandthentakeofftheapplication
tool.
1
3
4
2
►1. Application tool installation bolt 2. Holes in the
application tool 3.Adapter(requiredforsomeappli-
cation tools) 4.Protrusionsofthetoolange
Whenusingapplicationtoolswithadifferenttypeof
installation section, use a correct adapter (optional
accessory).