Makita DUR184L - Installing the grip; Installing the guard; Installing the wire guard

10 ENGLISH
Installing the grip
Fitthegripontothepipeandtightenitwiththeboltand
the knob.
1
3
2
►1. Grip 2. Bolt 3. Knob
Make sure that the grip is located in the straight area of
theshaftshowninthegure.
Installing the guard
WARNING: Never use the tool without the
guard illustrated in place.Failuretodosocan
causeseriouspersonalinjury.
CAUTION: Take care not to injure yourself on
the cutter for cutting the nylon cord.
1. Aligntheprojectionsontheprotectorwiththe
grooves of the motor housing.
1
2
3
►1. Protector 2.Projection3. Groove
2. Aligntheprojectionsontheprotectorholderwith
its counter parts of the motor housing.
1
2
►1. Protector holder 2.Projection
3. Tightenthehexboltssecurelytofastentheprotec-
tor and the protector holder.
1
►1.Hexbolt
Installing the wire guard
CAUTION: Before adjusting the wire guard,
wait for the cutting head comes to standstill. Do
not adjust the wire guard with your foot.