(2)
0.6 mm - 0.7 mm
(0.024” - 0.028”)
CHECKING THE SPARK PLUG
– Only use the supplied universal wrench to remove or to install the spark plug.
– The gap between the two electrodes of the spark plug should be 0.6 - 0.7 mm
(0.024” - 0.028”). If the gap is too wide or too narrow, adjust it. If the spark
plug is clogged or contaminated, clean it thoroughly or replace it.
Place the plug cap properly as illustrated after checking.
CAUTION: Never touch the spark plug connector while the engine is running
(danger of high voltage electric shock).
SUPPLY OF GREASE TO GEAR CASE
– Supply grease (Shell Alvania 2 or equivalent) to the gear case (1) through the
grease hole (2) every 30 hours. (Genuine MAKITA grease may be purchased
from your MAKITA dealer.)
CLEANING OF FUEL FILTER
WARNING: INFLAMMABLES STRICTLY PROHIBITED
Interval of inspection: Monthly (every 50 operating hours)
Suction head in the fuel tank
Check the fuel lter (1) periodically. To check the fuel lter, follow the steps
below:
1. Remove the fuel tank cap, drain the fuel to empty the tank. Check the tank
inside for any foreign materials. If any, remove them.
2. Pull out the suction head by using a wire hook through the tank opening.
3. If the fuel lter clogged slightly, clean it. To clean it, gently shake and tap
it in fuel. To avoid damage, do not squeeze or rub it. The fuel used for the
cleaning must be disposed in accordance with the method specied by
regulations in your country.
If the fuel lter became hard or heavily clogged up, replace it.
4. After checking, cleaning or replacing, insert the fuel lter into the fuel pipe
(3) and x it by the hose clamp (2). Push the fuel lter in all the way to the
bottom of the fuel tank.
Clogged or damaged fuel lter can cause insufcient fuel supply and reduce
engine power. Replace the fuel lter at least quarterly to ensure satisfactory fuel
supply to the carburetor.
(1)
(2)
(3)
(1)
To Next Page
Loading...
Need help?
General
