Makita LS1011N - Repair - 45° Bevel Angle Adjustment; 45° Bevel Angle Adjustment

Repair
P 12 / 13
2. 45° bevel angle
Push the motor section to the nearest position to guide rule, and fasten screw M6 x 20 to secure the motor section
in the above position.
Loosen lever 125 to the direction indicated with arrow as illustrated in Fig. 15A . Tilt the motor section fully
to the left.
Screw M6 x 20
Lever 125
View from lever 125 side
Saw blade
Tilt fully to the left.
Hex bolt M8 x 30
Adjust the saw blade's 45 ° with hex bolt M8 x 30
and 1R207 "45 degrees set square" as illustrated in
Fig. 15 B.
After adjusting, fasten hex bolt M8 x 30 again.
No.1R207 : 45 Degrees set square
60mm
75mm
25mm
20mm
Fig. 15 B
Fig. 15A