16
Horizontal vise (optional accessory)
The horizontal vise can be installed in two positions on either
the left or right side of the base. When performing 15° or
greater miter cuts, install the horizontal vise on the side
opposite the direction in which the turn base is to be turned.
By flipping the vise nut to the left, the vise is released, and
rapidly moves in and out. To grip the workpiece, push the
vise knob forward until the vise plate contacts the workpiece
and flip the vise nut to the right. Then turn the vise knob
clockwise to secure the workpiece.
The maximum width of workpiece which can be secured by
the horizontal vise is 200 mm (7-7/8”).
When installing the horizontal vise on the right side of the
base, also use the sub-fence R to secure the workpiece
more firmly. Refer to the “Sub-fence R” section described on
previously for installing the sub-fence R.
CAUTION:
• Always rotate the vise nut to the right fully when securing
the workpiece. Failure to do so may result in insufficient
securing of the workpiece. This could cause the
workpiece to be thrown, cause damage to the blade or
cause the loss of control, which can result in
PERSONAL INJURY.
Holders
The holders can be installed on either side as a convenient
means of holding workpieces horizontally. Slip the holder
rods into the holes in the base and adjust their length accord-
ing to the workpiece to be held. Then tighten the holders
securely with the screws.
CAUTION:
• Always support long workpieces level with the top
surface of the turn base for accurate cuts and to prevent
dangerous loss of control of the tool.
OPERATION
CAUTION:
• Before use, be sure to release the handle from the
lowered position by pulling the stopper pin.
• Make sure the blade is not contacting the workpiece, etc.
before the switch is turned on.
1. Vise plate
2. Vise nut
3. Vise knob
1
2 3
001550
1. Holder
1
001544
To Next Page
Loading...
