Makita LS1219/1 - Page 28

28 ENGLISH
1
2
3
►1. Triangular rule 2. Saw blade 3. Top surface of
turn base
Check if the side of the blade squares with the turn base
surface once again. Loosen the screw on the pointer.
Align the pointer with 0° position in the bevel angle
scale and then tighten the screw.
45° bevel angle
NOTICE: Before adjusting the 45° bevel angle,
nish 0° bevel angle adjustment.
Loosen the knob and fully tilt the carriage to the side
that you want to check. Check if the pointer indicates
the 45° position in the bevel angle scale.
If the pointer does not indicate the 45° position, align
itwith45°positionbyturningtheadjustingboltonthe
opposite side of the bevel angle scale.
1
2
►1.Left45°adjustingbolt2.Right45°adjustingbolt
Adjusting the laser line position
For model LS1219L only
WARNING: The tool must be plugged in while
adjusting the laser line. Take extra care not to
switch on the tool during adjustment. Accidental
startupofthetoolmayresultinseriouspersonalinjury.
CAUTION: Never look directly into the laser
beam. Direct eye exposure to the beam could cause
serious damage to your eyes.
NOTICE: Check the position of laser line regu-
larly for accuracy.
NOTICE: Beware that impacts to the tool. It may
cause the laser line to be misaligned or may cause
damage to the laser, shortening its life.
NOTICE: Have the tool repaired by a Makita
authorized service center for any failure on the
laser unit.
The movable range of laser line is decided by the range
adjustmentscrewsonbothsides.Performfollowing
procedures to alter the laser line position.
1. Unplug the tool.
2. Draw a cutting line on the workpiece and place it
on the turn base. At this time, do not secure the work-
piece with a vise or similar securing device.
3. Lower the handle and align the cutting line with
the saw blade.
4. Return the handle to the original position and
secure the workpiece with the vertical vise so that the
workpiece does not move from the position you have
determined.