Makita LS1219/1 - After Use; Optional Accessories

30 ENGLISH
1
►1. Brush holder cap
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 min-
utes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If
the electric brake is not working correctly, have the tool
repaired by a Makita service center.
After use
After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
To maintain product SAFETY and RELIABILITY,
repairs,anyothermaintenanceoradjustmentshould
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
WARNING: These Makita accessories or
attachments are recommended for use with your
Makita tool specied in this manual. The use of
any other accessories or attachments may result in
seriouspersonalinjury.
WARNING: Only use the Makita accessory
or attachment for its stated purpose. Misuse of
an accessory or attachment may result in serious
personalinjury.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Steel&Carbide-tippedsawblades
• Verticalvise
• Horizontalvise
• Crownmoldingstopperset
• Dustbag
• Triangularrule
• Hexwrench
• Hexwrench(forLS1219L)
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.