Makita M9511 - Page 6

6 ENGLISH
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing side grip (handle)
Optional accessory for M9509 in some countries
CAUTION: Always be sure that the side grip is
installed securely before operation.
Screw the side grip securely on the position of the tool
asshowninthegure.
Installing or removing wheel guard
(For depressed center wheel)
WARNING: When using a depressed center
wheel, the wheel guard must be tted on the tool
so that the closed side of the guard always points
toward the operator.
Mount the wheel guard with the protrusions on the
wheel guard band aligned with the notches on the bear-
ing box. Then rotate the wheel guard to such an angle
that it can protect the operator according to work. Be
sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
1
2
3
►1. Wheel guard 2. Bearing box 3. Screw
Installing or removing depressed
center wheel
Optional accessory
WARNING: When using a depressed center
wheel, the wheel guard must be tted on the tool
so that the closed side of the guard always points
toward the operator.
CAUTION: Make sure that the mounting part
of the inner ange ts into the inner diameter of
the depressed center wheel perfectly. Mounting
theinnerangeonthewrongsidemayresultinthe
dangerous vibration.
Mounttheinnerangeontothespindle.Makesuretot
thestraightpartoftheinnerangeontothestraightpart
at the bottom of the spindle. Fit the depressed center
wheelontheinnerangeandscrewthelocknutonto
the spindle.
In case of mounting a depressed center wheel thinner
than4mm(5/32″),placethelocknutsothattheprotru-
sion on the lock nut faces outside. Otherwise, place it
sothattheprotrusiononittsintotheinnerdiameterof
the wheel.
1
2
4
3
►1. Lock nut 2. Depressed center wheel 3. Inner
ange4. Mounting part
Totightenthelocknut,presstheshaftlockrmlyso
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
1
2
►1. Lock nut wrench 2. Shaft lock
To remove the wheel, follow the installation procedure
in reverse.