Makita MP100DZ - Disposing of dust for high performance filter; Cleaning the high performance filter; Reassembly; Reassembly for normal filter

7 ENGLISH
Disposing of dust for high
performance lter
Inordertodropduststickingonthelterinthecapsule,
tap the capsule 4 or 5 times with your hand.
Now point suction inlet downwards, turn capsule in
direction of arrow in diagram, and disconnect capsule
slowly and straight.
2
1
►1. Capsule 2. Suction inlet
NOTE: Dust may spill out when capsule is opened, so
be sure to set a garbage bag beneath capsule.
Remove accumulated dust from inside of capsule and
offofhighperformancelter.
1
2
►1. Capsule 2.Highperformancelter
Twisthighperformancelterindirectionofarrowtounfas-
tensecuringlipfromcleanerunitandthenpulloffthelter.
1
►1. Securing lip
Cleanoutthenedustandlightlytaptodislodgedust
fromhighperformancelter.
Reassembly
Reassembly for normal lter
Putonthelterfullyinpositiononthecleanerunit.
1
►1. Filter
NOTICE: Make sure the lter is put on straight
without being peeled back.Ifthelterisputon
incorrectly as illustrated, dust will get into the motor
housing, and cause a motor failure.
1
►1. Filter
Installtheprelter.Atthistime,makesuretotwistthe
preltersothatthesecuringlipisrmlylockedinthe
cleaner unit.
2
1
►1.Prelter2. Securing lip