Makita VC3510 - Filter Cartridge Maintenance

- 16 -
SERVICE
Cod.
83 201BJA *
Cod.
83 035BHB
EN
2 .... FOAM FILTER (code 83 035BHB) (Fig.“D4”)
- Rinsethefoamlterwithwater.DO NOT use detergent.
- Replace if worn or torn.
3 .... FILTER CARTRIDGE (pack code 83 201BJA *)
- Tocleantheltercartridge,turnontheSelf-CleaningFilterfun-
ction by pressing the orange
momentary switch only
up to 30 seconds. Afterwards release the momentary switch
for15seconds;thecoilhastocooldown(g.“D5”).
- Switch in position 0 = Self-Cleaning Filter function disabled
(as described in point “A3”).
- Tothoroughlycleanthelterwashitasshowningure“D6”.
Before putting the cartridge back on, make sure it is completely
dry.
  Replacetheltercartridgeonlyifworn.
CAUTION:
Handle the lter cartridge carefully when wet (Fig. “D7”).
4 .... CLEANING THE DRUM (Fig.“D8”)
- Check the amount of vacuumed debris.
- Empty the drum when it is half full.
- Dry off the drum and accessories after vacuuming liquids.
5 .... REPLACING THE POWER CORD
- Contact an authorized technical service centre if the power
cord has been damaged, since special tools are needed to
replace it.
* Pack code