02.A 13-05-03
CONTENTS
Contents Page 02
Tools necessary for dismantling the various parts of the appliance: Page 03
Step 1 Removing the top cover (B360) Page 03
Step 2 Removing and/or dismantling the programmer knob assembly Page 03
Step 3 Removing and/or replacing the programmer (B290) from the control panel (B270) Page 04
Step 4 Removing and/or replacing the buttons (B210) and switches (B330-B340) from the control panel Page 04
Step 5 Removing and/or replacing the cover piece (B260) from the control panel (B270) Page 05
Step 6 Removing and/or replacing the control panel (B270) Page 05
Step 7 Removing and/or replacing the door microswitch (B590) Page 06
Step 8 Removing the door Page 06
Step 9 Removing the door glass (B120) Page 06
Step 10 Removing the door hinge (B060) Page 07
Step 11 Removing the door handle (B710) Page 07
Step 12 Removing the brush support brackets and relative humidity sensing brushes,
consisting of:
- Support bracket (A620)
- Brush holder (A610)
- Humidity sensing brush (A630)
- Pin (A640)
- Spring (A570) Page 08
Step 13 Removing and/or replacing the power supply cable and/or terminal block (B450) Page 08
Step 14 Removing and/or replacing heater element (B560) and air inspection cover (B051) Page 09
Step 15A For driers produced prior to week 18 of 2003
Removing and/or replacing:
- the manual reset safety thermostat (B006)
- the automatic reset maximum temperature thermostat (B030) Page 09
Step 15B For driers produced from week 18 of 2003 (from serial number 200318...)
Removing and/or replacing:
- the manual reset safety thermostat (B006)
- the automatic reset maximum temperature thermostat (B030) Page 09
Step 16A For driers produced prior to week 18 of 2003
Removing and/or replacing the rear panel (B580) Page 10
Step 16B For driers produced from week 18 of 2003 (from serial number 200318...)
Removing and/or replacing the rear panel (B580) Page 11
Step 17 Removing and/or replacing the rear drum seal with felt (B025) Page 12
Step 18 Removing and/or replacing the drive belt (A290) Page 12
Step 19 Removing and/or replacing the drum assembly (A300) Page 13
Step 20 Replacing and/or removing the drum paddle with probe (A320) and/or the drum paddle
without probe (A310) from the drum assembly (A300) Page 13
Step 21 Replacing and/or removing the slide blocks (A530) and the felt seal (A410) from the
drum support surround (A340) Page 13
Step 22 Removing and/or replacing the motor (A120) Page 14
Step 23 Removing and/or replacing the drum support surround (A340) Page 15
Step 24
Replacing and/or removing the left hand side panel (B040) and/or the right hand side panel (B230)
Page 16
Step 25 Removing and/or replacing the plastic plinth (B007) from the front panel (B070) Page 17
Step 26 Replacing the bottom panel (A260) Page 17
IMPORTANT:
This Manual must be used together with all the other technical documents appertaining to the product itself (Exploded views,
technical documents and any other technical information provided).
To Next Page
Loading...
