15
3 - Press and hold the «Small coffee» and «Large coffee» buttons (buttons no. 4 and no. 5) simultaneously for at
least 5 seconds. The white light will then ash rapidly - the machine is in programming mode.
4 - Lower the handle (no. 2) and press the coffee option to be programmed (button no. 4 for small coffee and
button no. 5 for large coffee).
5 - Once the required volume of coffee has been poured, press the same button again to stop serving and save
the selected volume.
6 - The white light will then stay ON - the programming has been saved for the button.
ANOMALIES
I CAN’T MAKE COFFEE.
Check that the switch (no. 8) is set to I.
Check that the white light is ON steady. You cannot make coffee while the machine is heating, this is normal (the
white light will ash slowly).
Check that the machine is not on standby. If so, press a coffee button (no. 4 or no. 5), or use the handle (no. 2,
open/close) to turn the machine ON. Wait until the machine reaches the required temperature (the white light
stays ON steady).
Check that the handle (no. 2) is lowered.
THE POD FAILS TO EJECT
Check that the pod tank is empty.
Raise or lower the handle to eject the pod (several times if necessary).
NO COFFEE IS SERVED
Check the level of water in the tank.
THE WHITE LIGHT FAILS TO COME ON
Check that the machine is plugged in.
THE WHITE LIGHT FLASHES RAPIDLY (UNLESS PROGRAMMING MODE IS SELECTED)
Check that the water tank (no. 7) is in position.
CLEANING
Turn the coffee machine off and allow to cool in full before cleaning. Unplug the coffee maker before cleaning.
Clean the body of the coffee machine, the water tank (no. 7), the pod tank (no. 9) and the dripp tray with a sponge
on a frequent and regular basis and leave to dry.
Reminder: Never immerse the machine in water to clean. Never place the machine or its accessories in
a dishwasher.
To Next Page
Loading...