8
Secure the power cord and make sure
that it cannot be pulled on inadvertently,
causing the appliance to fall down onto
the floor.
16. To operate the appliance, it must be
placed on a dry and level surface.
17. Always fill a sufficient amount of water
for warming. When doing this, place the
bottle or jar along with the baby food jar /
baby bottle basket into the appliance
first prior to filling the appliance with wa-
ter. To ensure optimum warming, make
sure that the interior compartment is
completely filled with water.
18. Never fill the appliance with water up to
the top edge.
19. Caution: During operation, the water
inside the appliance becomes very hot.
20. Never operate the Baby Food Warmer
without water or transport it during ope-
ration.
21. When the appliance is not in use, al-
ways disconnect the mains plug and
empty out the water. Caution: The wa-
ter inside the Baby Food Warmer can
get extremely hot.
22. Check the Baby Food Warmer each
time before use and only use it if the ap-
pliance and power cord are intact. At
the first sign of any damage, the com-
ponent in question must be either dispo-
sed of or repaired.
23. The appliance may only be opened by
an authorised service centre. Otherwise
the warranty is invalidated. Repairs may
only be performed by specialised per-
sonnel. Improper repairs can present
considerable safety hazards for users.
This also applies to the replacement of
the power cord.
24. Always keep the instruction manual in a
safe place.
2. Warming baby bottles
• Place the bottle to be warmed along with the baby food jar /
baby bottle basket into the Baby Food Warmer. Next, pour wa
-
ter into the interior compartment until it is completely filled up
and/or up to the filling level of the bottle. Make sure that no
water runs into the bottle or over the edge of the Baby Food
Warmer.
• Set the rotary knob (temperature controller) to the desired tem-
perature range, the red lamp will light up. Depending on the
initial temperature of the food, for small (approx. 160 ml) and
large (approx. 270 ml) baby bottles, we recommend turning the
temperature controller to setting 4 or 5.
• To help the heat to spread evenly more quickly, stir the contents
of the bottle repeatedly with a spoon. The time it takes to warm
up the contents can vary depending on the bottle size, quantity
and initial temperature. In this regard, please consult our tab-
le with the respective guideline values on page 3. As soon as
the corresponding temperature is reached, the indicator lamp
constantly switches on and off, because the water is kept at
a constant temperature. Further information on keeping baby
food warm can be found on page 3.
• Take out the bottle.
• After use, be sure to switch off the baby food warmer by tur
-
ning the rotary knob to stop in an anti-clockwise direction.
Always disconnect the mains plug and empty out the water.
Caution: the water inside the baby food warmer can get extre-
mely hot.
For your child’s health – warning notice:
Before feeding your child, please check that the contents have
the right temperature. Please start by using a spoon to stir the
contents of the jar so that the heat spreads evenly more quickly.
Then sprinkle 2 to 3 drops of the contents onto the back of your
hand (tip: try it on the groove on the back of your hand that forms
when spreading your thumb and first finger apart) or on the pulse
of your wrist. Do not overheat the contents of the bottle and do
not reheat. Dispose of any leftovers after feeding.
3. Warming jars of baby food
• Please remove the label from the jar of baby food. It may other
-
wise become detached during warming and get stuck inside the
interior compartment.
• Remove the lid from the jar of baby food.
• Place the jar along with the baby food jar / bottle basket into the
Baby Food Warmer. Pour water into the internal compartment
until it is completely filled up. Make sure that no water runs into
the jar or over the edge of the Bottle and Baby Food Warmer.
Set the rotary knob (temperature controller) to the desired tem-
perature range, the red lamp will light up. Depending on the
initial temperature of the food, for small jars and large jars, we
recommend turning the temperature controller to setting 4 or
5. To help the heat spread evenly more quickly, stir the con-
tents of the bottle repeatedly. The time it takes to warm up the
contents can vary depending on the type of food, quantity and
initial temperature. In this regard, please consult our table with
the respective guideline values on page 3. As soon as the corre-
sponding temperature is reached, the indicator lamp constantly
switches on and off, because the water is kept at a constant
temperature.
• Take out the jar.
• After use, be sure to switch off the baby food warmer by turning
the rotary knob to stop in an anti-clockwise direction. Always
disconnect the mains plug and empty out the water. Caution:
the water inside the baby food warmer can get extremely hot.
• To keep the food warm, turn the rotary knob down to setting 3.
For your child’s health – warning notice:
Before feeding your child, please check that the contents have
the right temperature. Please start by using a spoon to stir the
To Next Page
Loading...