Man E3262 LE212 User Manual

Maintenance and Care
74
Carefully read these Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
E1 S Check for leaks
S Check threaded connections
S Change engine oil/analyse oil*
)
S Change oil filter*
)
S Record operation data
S Check start procedure
S Check/set throttle valve
S Clean/check gas filter
S Clean/check air filter
S Clean/check impulse sensor
S Check coolant concentration
S Check ignition timing
S Check cooling circuit/system pressure
S Measure crankcase pressure
S Measure exhaust back pressure inclu
ding catalytic converter
S Check emissions and oxygen sensor
S Check external side of exhaust system
for dirt, clean if necessary
E2 S Check for leaks
S Check threaded connections
S Change engine oil/analyse oil*
)
S Change oil filter*
)
S Record operation data
S Check spark plugs
S Check start procedure
S Check intake vacuum
E3 S Check valve clearance, adjust if ne
cessary
S Change spark plugs
S Measure compression
S Check/set throttle valve
S Clean/check gas filter
S Clean/check air filter
S Clean/check impulse sensor
S Check coolant concentration
S Check/change oil separator
S Check ignition timing
S Check cooling circuit/system pressure
S Measure crankcase pressure
S Measure exhaust back pressure inclu
ding catalytic converter
S Check/clean mixture cooler
S Check emissions and oxygen sensor
S Check/calibrate sensors
S Check exhaust system threaded
connections
R1 S Replace coolant
S Measure crankshaft axial play
S Replace turbocharger
S Replace exhaust pipe multi-piece ring
R2 S Replace cylinder liner
S Check/replace connecting rods
S Replace piston rings
S Replace cylinder heads
R3 S Recondition engine
*) The engine oil service life is to be determined according to MAN Works Standard M 3271-2 using regu
lar oil analysis depending on the operating conditions and the engine oils used.
- Regular analysis of the oil is to be made for fluctuating gas compositions
Oil analysis table
Special gases (biogas/landfill gas/sewage gas)
Engine operating hours Oil operating hours
50 oper. h 50 oper. h Oil change
up to max. 450 oper. h 400 oper. h Oil change with oil analysis
The oil service life can be increased in stages by analysing the oil (in stages up to a max. 50 oper. h) *
)
*
)
Only after consultation with MAN Diesel SE, Dept. SUEP

Man E3262 LE212 Specifications

General

Brand	Man
Model	E3262 LE212
Category	Engine
Language	English