Manitou 150 AETJ - CHECK Telescope Setting

CHECK Telescope setting
t
IMPORTANT
t
It is recommended that the jib telescope chocking is adjusted if the clearances are higher than the maximum values,
e REPAIR MANUAL.
- Check all the wheel nut tightening torques
1
:
• 69N.m ± 6.5N.m
- Raise the jib slightly.
- Extend the telescope for 1 second.
- Check the clearances between the pads and the telescope:
•
A
(upper pads
2
) must be between 0.5mm and 1mm.
•
B
(side pads
3
) must be between 0.25mm and 0.5mm on either side.
- Fully extend the telescope.
- Check the clearances
A
and
B
again.
- Fully retract the telescope.
- Lower the jib completely.
- Take off the cover
4
.
- Raise the main arm slightly.
- Place several wooden pallets under the basket.
- Slowly lower the main arm until the pads
5
are in contact with the main arm.
- Check the clearances between the pads and the main arm:
•
C
(upper pads
6
) must be between 0.5mm and 1mm.
•
D
(side pads
7
) must be between 0.25mm and 0.5mm on either side.
- Raise the main arm slightly.
- Remove the wooden pallets.
- Fully lower the main arm.
- Turn the platform off.
- Put the cover
4
back in place.
3 - 31
1
1
1
A
B
2 3
4
C
D
6
7
5
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L