Manitou 150 AETJ - Replace; Turntable Motor Oil; Wheel Reduction Gear Oil

REPLACE Wheel reduction gear oil
t
IMPORTANT
t
It is recommended that the oil is slightly warm before being changed.
NOTE: Drain and fill the wheel reduction gears one by one.
DRAIN THE OIL
- Remove the rear wheels,
eOCCASIONAL MAINTENANCE.
- Release the brakes, eOCCASIONAL MAINTENANCE.
- Turn the wheel reduction gear to place the plug
1A
at the bottom and the plug
1B
on the right.
- Place a drain pan under the plug
1A
.
- Remove the 2 plugs.
- Wait until the wheel reduction gear is completely empty.
FILL THE WHEEL REDUCTION GEARS
- Turn the wheel reduction gear to place the
B
hole at the top and the
A
hole
on the right.
- Clean around the holes with a clean cloth.
- Fill the wheel reduction gear with new oil, eLUBRICANTS. The level is correct when
the oil reaches the rim of the filling hole
A
.
- Refit the 2 plugs:
• Tightening torque = 20 N.m ±2 N.m.
- Reapply the brakes,
eOCCASIONAL MAINTENANCE.
- Refit the rear wheels, eOCCASIONAL MAINTENANCE.
REPLACE Turntable motor oil
t
IMPORTANT
t
It is recommended that the oil is slightly warm before being changed.
DRAIN THE OIL
- Open the left-hand turntable cover.
- Place a drain pan under the drain plug
1
.
- Remove the drain plug and the filler plug
2
.
- Wait until the crankcase is completely empty.
FILL THE TURNTABLE MOTOR
- Clean around the drain hole with a clean cloth.
- Refit the drain plug.
- Fill the turntable motor with new oil,
eLUBRICANTS.
- Clean the dipstick on the filler cap with a clean cloth and put it back in place.
- Remove the filler cap. The level is correct when the oil is between the 2
A
and
B
notches.
- If the level is low:
• Add oil until the correct level is reached, eLUBRICANTS.
• Refit the filler cap.
- If the level is correct:
• Refit the filler cap.
3 - 39
B
A
1B
1A
2
1
2
A
B
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L