1-191-19
BATTERY CHARGE
- In the case of electric platforms, in order to preserve the batteries’ life and their capacity, check them periodically and keep the charge
level constant (see: 3 - MAINTENANCE).
PROTECTING THE PLATFORM
- Protect cylinder rods which are not be retracted from corrosion.
- Wrap the tyres.
NOTE: If the platform is to be stored outdoors, cover it with a waterproof tarpaulin.
BRINGING THE PLATFORM BACK INTO SERVICE
- Remove the waterproof adhesive tape from all the orifices.
- Refit the intake hose.
- Reconnect the engine cut-off solenoid.
- Refit and reconnect the battery.
- Remove the protection from the cylinder rods.
- Perform the daily service (see: 3 - MAINTENANCE).
- Empty and replace the fuel and replace the fuel filter (see: 3 - MAINTENANCE).
- Refit the drive belts and adjust the tension (see: 3 - MAINTENANCE).
- Turn the engine over with the starter to allow the oil pressure to rise.
- Lubricate the platform completely (see: 3 - MAINTENANCE: SERVICING SCHEDULE).
Make sure the area is adequately ventilated before starting up the platform.
- Start up the platform, following the safety instructions and regulations (see: DRIVING INSTRUCTIONS).
-
Carry out all the lifting system’s hydraulic movements right up to the limit switches for each cylinder.
To Next Page
Loading...
