Manitou 170 AETJ L User Manual

1 - 14
IF THE PLATFORM IS NOT TO BE USED FOR A LONG TIME
INTRODUCTION
The following recommendations are intended to prevent the platform from being damaged when it is withdrawn from service
for an extended period.
t
IMPORTANT
t
Procedures to follow if the platform is not to be used for a long time and for starting it up again afterwards must be performed by your dealership.
This period of long-term stoppage must not exceed 12 months.
PREPARING THE PLATFORM
- Clean the platform thoroughly.
- Check and repair any leaks of fuel, oil, water, etc.
- Replace or repair any worn or damaged parts.
- Touch up the paintwork if necessary.
- Make sure the cylinder rods are in the retracted position (if applicable).
- Shut down the platform.
- Release the pressure in the hydraulic circuits.
PROTECTING THE ENGINE (DIESEL PLATFORM)
- Fill the tank with fuel (e 3 - MAINTENANCE).
- Replace the engine oil and oil filter (e 3 - MAINTENANCE).
- Drain and replace the coolant (e 3 - MAINTENANCE).
- Disconnect the battery and store it in a safe place away from the cold, after charging it to a maximum.
- Block the outlet with waterproof adhesive tape.
- Remove the belts and store them in a safe place.
- Disconnect the engine cut-off solenoid on the injection pump and carefully insulate the connection.
BATTERY CHARGING (ELECTRIC PLATFORM)
- In order to preserve battery life and capacity, check them periodically and keep the charge level constant (e2-DESCRIPTION).
- Do not leave the battery charger connected during a lightning storm.
PROTECTING THE PLATFORM
- Protect cylinder rods which are not be retracted from corrosion.
- Wrap the wheels.
NOTE: If the platform is to be stored outdoors, cover it with a waterproof tarpaulin.
BRINGING THE PLATFORM BACK INTO SERVICE
DIESEL PLATFORM
- Remove the protection from the cylinder rods and wheels.
- Refit and reconnect the battery.
- Remove the waterproof adhesive tape from the exhaust outlet.
- Empty and replace the fuel and replace the fuel filter (
e 3 - MAINTENANCE).
- Refit the belts and adjust their tension (e3-MAINTENANCE).
- Reconnect the engine cut-off solenoid.
t
IMPORTANT
t
Make sure the area is adequately ventilated before starting up the platform.
- Start up the platform, following the safety instructions and regulations.
- Perform the daily maintenance operations (e 3 - MAINTENANCE).
DIESEL AND ELECTRIC PLATFORM
- Lubricate the platform completely (
e3-MAINTENANCE).
- Carry out all the lifting system’s hydraulic movements right up to the limit switches for each cylinder.
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L

Manitou 170 AETJ L Specifications

General

Brand	Manitou
Model	170 AETJ L
Category	Lifting Systems
Language	English