Manitou AETJ 43 - Overload Sensors - Settings

129
ELECTRICITY
80
547379EN
80 (08/03/2017)
OVERLOAD SENSORS  SETTINGS
PROCEDURE
- Set the basket to the low position, keeping the access platform
switched on.
- Remove the cover (1, 080 - 112).
- Connect the calibrator to the access platform (680.3.4 VARIABLE
SPEED CONTROLLERS  CONTROL AND SETTINGS, 5 115)
Overload spring pre-tensioning adjustment
- Place a load in the basket and distribute it evenly across the oor.
3 - 120 AETJL : 170 kg (375 lbs)
3 - 150 AETJC - 150 AETJC 3D - AETJ43 - AETJ 43 3D : 170 kg (375 lbs)
3 - 150 AETJL : 200 kg (441 lbs)
3 - 170 AETJL : 170 kg (375 lbs)
- Tighten the bolt (2, 080 - 112) in such a way that it remains free
to rotate at the end of the operation with minimum play.
Overload sensor adjustment
- Undo the lock nuts (1, 080 - 113) then tighten the overload screws
(2, 080 - 113) to their maximum extent.
- Place a load in the basket and distribute it evenly across the oor.
3 - 120 AETJL: 230 kg (507 lbs)
3 - 150 AETJC - 150 AETJC 3D : 230 kg (507 lbs)
3 - 150 AETJL: 250 kg (551 lbs)
3 - 170 AETJL - AETJ 49: 230 kg (507 lbs)
- Sensor SQ5a: test menu 1.3.16
- Sensor SQ5b: test menu 2.4.9
- Identify sensor SQ5a (yellow ring on the power cable) and loosen
the overload screw (2, 080 - 113) until the calibrator displays OPEN
instead of CLOSED.
- Identify sensor SQ5b (yellow ring on the power cable) and loosen
the overload screw (2, 080 - 113) until the calibrator displays CLOSED
instead of OPEN.
80 - 112
2
1
80 - 113
1
2
3
1
2
3