Manitou AETJ 43 - Hydraulic Control and Adjustment; Main Circuit - Pressure Setting; Steering, Basket;Turret Rotation Circuit - Pressure Setting

47
HYDRAULIC
70
547379EN
70 (08/03/2017)
70.3 HYDRAULIC CONTROL AND ADJUSTMENT
CAUTION
In this chapter, unless specically indicated, in order to view the setting pressure values and choose
the appropriate pressure gauge, refer to the hydraulic diagrams (670.1.1 679449  HYDRAULIC DIAGRAM,
5 35))37+ (670.1.2 685268  HYDRAULIC DIAGRAM, 5 39)41
70.3.1 MAIN CIRCUIT  PRESSURE SETTING
Setting the main pressure relief valve (14, 070.1.1), (14,, 070.1.2)
- On the distributor, connect a pressure gauge to M (1, 070  11).
- Switch on the access platform.
- Control the lowering of arms 1/2 and maintain the control when
the cylinder reaches the stop.
- Check that the pressure gauge displays the pressure recommended
in the hydraulic diagram.
- As required, adjust the setting of the main relief valve (2, 070  11).
70.3.2 STEERING, BASKET/TURRET ROTATION CIRCUIT  PRESSURE SETTING
Setting the pressure relief valve (13, 070.1.1), (13, 070.1.2)
- On the distributor, connect a pressure gauge to M1 (1, 070  12).
- Switch on the access platform.
- Control the steering to one side and maintain the control when
the cylinder reaches the stop.
- Check that the pressure gauge displays the pressure recommended
in the hydraulic diagram.
- As required, adjust the setting of the pressure reducer (2, 070  12)
M
70 - 11
2
1
M1
70 - 12
1
2