2-46
18 - HYDRAULIC CONTROLS AND TRANSMISSION CUT-OFF
Do notattempt to alter the hydraulic system pressureby interfering withthe pressure regulating valve.In the eventof suspected malfunction, contact your dealer.
ANY ALTERATION MAY RENDER THE WARRANTY NULL AND VOID.
Use the hydraulic controls carefully without jerking, to avoid accidents caused by shaking the lift truck.
MT 732 Série E-E3
MT 932 Série E-E3
A - Lifting and telescoping control lever.
B - Lifting and tilting control lever.
C - Attachment cut-off control lever.
D - Transmission cut-off control button.
E - Forward/neutral/reverse selector control button.
LIFTING THE LOAD
- Move lever A or B backwards to lift.
- Move lever A or B forwards to lower.
TELESCOPING
- Move lever A to the right to extend.
- Move lever A to the left to retract.
NOTE: Only for
MT 932 Série E-E3
When completely retracting the telescopes, insistently operate the control so as to allow
all the telescopes to retract fully.
TILT OF CARRIAGE
- Move lever B to the left to excavate.
- Move lever B to the right to tip.
ATTACHMENT
- Raise lever C and turn to the left or right.
TRANSMISSION CUT-OFF
- Switch D (see: 2 - DESCRIPTION: 5 - SWITCHES).
FORWARD/REVERSE SELECTOR
- Switch E (see 2 - DESCRIPTION: 17 - FORWARD/NEUTRAL/REVERSE GEAR SELECTOR).
MT 1030 S Turbo Série 5-E3
A - Lifting and telescoping control lever.
B - Lifting and tilting control lever.
E - Attachment cut-off control lever.
F - Transmission cut-off control button.
G - Forward/neutral/reverse selector control button.
LIFTING THE LOAD
- Move lever A or B backwards to lift.
- Move lever A or B forwards to lower.
TELESCOPING
- Move lever A to the right to extend.
- Move lever A to the left to retract.
NOTE: When completely retracting the telescopes, insistently operate the control so as to allow
all the telescopes to retract fully.
TILT OF CARRIAGE
- Move lever B to the left to excavate.
- Move lever B to the right to tip.
L.H. STABILIZER
- Move lever C forwards to lower.
- Move lever C backwards to lift.
NOTE: The stabilizers can only be raised after the boom has been retracted.
R.H. STABILIZER
- The lever D forwards when lowering.
- The lever D backwards when lifting.
NOTE: The stabilizers can only be raised after the boom has been retracted.
ATTACHMENT
- Raise lever E and turn to the left or right.
TRANSMISSION CUT-OFF
- Button F (see: 2 - DESCRIPTION: 5 - SWITCH PANEL).
FORWARD/REVERSE SELECTOR
- Switch G (see 2 - DESCRIPTION: 17 - FORWARD/NEUTRAL/REVERSE GEAR SELECTOR).
N°258969N° 254040
D
E
A
B
C
A
B
F
G
E
D
C
To Next Page
Loading...
