2 - 78
DESCRIPTION AND USE OF ELECTRIC AND HYDRAULIC OPTIONS
1 - REVOLVING LIGHT
The revolving light is dismountable to make it possible, for example, to reduce the
bulkiness of the lift truck or to avoid being stolen.
- Loosen nut 1 and remove the revolving light.
- Protect mounting 2 with cap 3.
2 - REVERSE BUZZER ALARM
3 - BATTERY CUT-OFF
4 - DIGICODE ANTI-THEFT SYSTEM
MC 30 Série 3-E2 M26-2 Série 3-E2 M26-4 Série 3-E2 M40-4 Série 3-E2
M30-2 Série 3-E2 M30-4 Série 3-E2 M50-4 Série 3-E2
FUNCTIONING
- Switch on the lift truck: LED A flashes red.
- Enter your user code followed by "VAL": LED A goes out.
- The entry of each digit of your code is confirmed by LED A lighting up green. If you make
an error, press the "ANN" key and re-enter your code in full.
- Start the lift truck within the next 30 seconds; otherwise the anti-theft system will react
and LED A flashes red.
NOTE: You can restart the lift truck within 12 seconds of stopping it: after this time, the
anti-theft system reacts and LED A flashes red.
5 - FINTRONIC ANTI-START SYSTEM
MC 30 Série 3-E2 M26-2 Série 3-E2 M26-4 Série 3-E2 M40-4 Série 3-E2
M30-2 Série 3-E2 M30-4 Série 3-E2 M50-4 Série 3-E2
FUNCTIONING
- Switch on the lift truck and set the black key A next to the antenna B (maximum 80 mm).
- Wait a few seconds for red LED C to go out before starting the lift truck.
NOTE: You can restart the lift truck within 20 seconds of stopping it: after this time, the
anti-start system reacts and LED C flashes red.
1
3
2
3
A
A
B
C
To Next Page
Loading...