Manitou M30-4 3-E2 Series - Page 146

3 - 43
E11 - REAR WHEELS REDUCERS OIL
DRAIN
M26-4 Série 3-E2 M40-4 Série 3-E2
M30-4 Série 3-E2 M50-4 Série 3-E2
Place the lift truck on level ground with the I.C. engine stopped and the reducers oil still
warm.
Dispose the drain oil in an ecological manner.
- Drain and change each rear wheel reducer.
- Place drain plug 1 (fig. E11) in position A.
- Place a container under the drain plug and unscrew the plug.
- Let the oil drain fully.
- Place the drain port in position B, i.e. in a level port.
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by level port 1 (fig. E11).
- The level is correct when the oil level is flush with the edge of the hole.
- Refit and tighten the drain plug 1 (fig. E11) (tightening torque 34 to 49 N.m).
E11
1
B
A