Manitou MC 50 POWERSHIFT 3-E2 Series - Page 145

3 - 42
E8 - SEAT BELT
CHECK
SEAT BELT WITH TWO ANCHORING POINTS
- Check the following points:
• Fixing of the anchoring points on the seat.
• Cleanness of the strap and the locking mechanism.
• Triggering of the locking mechanism.
• Condition of the strap (cuts, curled edges).
REELED SEAT BELT WITH TWO ANCHORING POINTS
- Check the points listed above together with the following points:
• The correct winding of the belt.
• Condition of the reel guards.
• Roller locking mechanism when the strap is given a sharp tug.
NOTE: After an accident, replace the seat belt.
Under no circumstances should you use the lift truck if the seat belt is faulty (fixing, locking, it has cuts or tears, etc). Repair or replace
the seat belt immediately.
E9 - FRONT WHEELS REDUCERS OIL
DRAIN
Place the lift truck on level ground with the I.C. engine stopped and the reducers oil still
warm.
Dispose the drain oil in an ecological manner.
- Drain and change each front wheel reducer.
- Place drain plug 1 (fig. E9) in position A.
- Place a container under the drain plug and unscrew the plug.
- Let the oil drain fully.
- Place the drain port in position B, i.e. in a level port.
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by level port 1 (fig. E9).
- The level is correct when the oil level is flush with the edge of the hole.
- Refit and tighten the drain plug 1 (fig. E9) (tightening torque 34 to 49 N.m).
E10 - REAR AXLE DIFFERENTIAL OIL
DRAIN
M26-4 Série 3-E2 M40-4 Série 3-E2
M30-4 Série 3-E2 M50-4 Série 3-E2
Place the lift truck on level ground with the I.C. engine stopped and the differential oil still
warm.
Dispose the drain oil in an ecological manner.
- Place a container under drain plugs 1 (fig. E10) and unscrew the plugs.
- Remove level plug 2 (fig. E10) and filler plug 3 (fig. E10) in order to ensure that the oil is
drained properly.
- Refit and tighten drain plugs 1 (fig. E10) (tightening torque 34 to 49 N.m).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by filler port 3 (fig. E10).
- The level is correct when the oil level is flush with the edge of port 2 (fig. E10).
- Check for any possible leaks at the drain plugs.
- Refit and tighten level plug 2 (fig. E10) (tightening torque 34 to 49 N.m) and filler plug 3 (fig. E10) (tightening torque 34 to 49
N.m).
E9
1
B
A
E10
3
2
1
1
1