2 - 66
3 - CONTROL AND SIGNAL LIGHTS PANEL
MC 40 POWERSHIFT Série 3-E2
MC 50 POWERSHIFT Série 3-E2
MC 60 POWERSHIFT Série 3-E2
MC 70 POWERSHIFT Série 3-E2
CONTROL INSTRUMENTS
A - HOURMETER
B - FUEL LEVEL
Red zone B1 indicates that you are using the reserve supply and that
time of use is limited.
SIGNAL LIGHTS
When activating the electrical system of the lift truck, all the red lamps
and the panel's buzzer must light to indicate their good working order. If
one of the red lamps or the buzzer does not function, carry out the
necessary repairs.
C - RED TRANSMISSION OIL TEMPERATURE LAMP
The lamp and the buzzer come on when the converter oil temperature is abnormally high. Stop the lift truck and look for the cause
of this overheating.
D - RED BRAKING OIL LEVEL LAMP
If the lamp and the buzzer come on, when the lift truck is running, stop the I.C. engine immediately and check the braking oil level.
In the event of an abnormal dropping of the level, consult your dealer.
E - RED I.C. ENGINE WATER TEMPERATURE LAMP
If the lamp and the buzzer come on when the lift truck is running, stop the I.C. engine immediately and investigate the cooling
system for the cause of the malfunction.
F - RED PARKING BRAKE LAMP
This lamp comes on when the parking brake is applied.
G - RED ALTERNATOR CHARGE LAMP
If the lamps C - D - E - G - H - I and the buzzer come on, when the lift truck is running, stop the I.C. engine immediately and check
the electrical circuit as well as the alternator belt.
H - RED I.C. ENGINE OIL PRESSURE LAMP
If the lamp and the buzzer come on when the lift truck is running, stop the I.C. engine immediately and look for the cause (see
oil level in I.C. engine crankcase).
I - RED AIR FILTER CLOGGED LAMP
The lamp and buzzer come on when the air filter cartridge is clogged up. Stop the lift truck and carry out the necessary repairs
(see cleaning and replacement requirements in chapter: 3 - MAINTENANCE: FILTERS CARTRIDGES AND BELTS).
J - BLUE MAIN BEAM LAMP
K - GREEN INDICATOR LAMP
To Next Page
Loading...
