14
MEZZER SERVICE MANUAL
Pro DAMPER SERVICE
1
2
Using a 2mm Hex wrench remove
the screw of the red “LO-SPEED”
MC2 knob.
Note: Be sure to hold the knob
still while removing the screw. The
damper adjuster may be damaged
if the knob is over torqued.
EXPERT SKIP TO PAGE 23
Use a non-marring pick or pliers
with non-marring barrier to remove
the red “LO-SPEED” compression
knob by lifting straight up.
3
With a 11mm socket, unthread the
exposed nut and remove the black
“HI-SPEED” adjustment knob.
Note: Be sure to hold the knob
still while removing the nut. The
damper adjuster may be damaged
if the knob is over torqued.
To Next Page
Loading...
